Show Ip Igmp Snooping Mrouter - Cisco Catalyst 4500 Series Command Reference Manual

show ip igmp snooping mrouter

show ip igmp snooping mrouter
To display information on the dynamically learned and manually configured multicast switch interfaces,
use the show ip igmp snooping mrouter command.
Syntax Description vlan vlan-id
Defaults
This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(19)EW
Usage Guidelines You can also use the
address table for a VLAN that has IGMP snooping enabled.
You can display IGMP snooping information for the VLAN interfaces by entering the show ip igmp
interface vlan vlan-num command.
Examples This example shows how to display snooping information for a specific VLAN:
Switch# show ip igmp snooping mrouter vlan 1
vlan
-----+----------------------------------------
1
Switch#
Related Commands Command
ip igmp snooping vlan mrouter
show ip igmp interface
show mac-address-table multicast
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-754
show ip igmp snooping mrouter [vlan vlan-id]
(Optional) Specifies a VLAN; valid values are from 1 to 1001 and from 1006 to 4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
show mac-address-table multicast
ports
Gi1/1,Gi2/1,Fa3/48,Switch
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
command to display entries in the MAC
Description
Statically configures a Layer 2 interface as a multicast
router interface for a VLAN.
Displays the information about the IGMP-interface status
and configuration.
Displays information about the multicast MAC address
table.
OL-27596 -01