Ip Source Binding - Cisco Catalyst 4500 Series Command Reference Manual

ip source binding

ip source binding
To add or delete a static IP source binding entry, use the ip source binding command. To delete the
corresponding IP source binding entry, use the no form of this command.
Syntax Description
ip-address
mac-address
vlan vlan-id
interface interface-name
Defaults
This command has no default settings.
Command Modes
Global configuration mode
Command History Release
12.1(19)EW
Usage Guidelines
The ip source binding command is used to add a static IP source binding entry only.
The no form of this command deletes the corresponding IP source binding entry. For the deletion to
succeed, all required parameters must match.
Each static IP binding entry is keyed by a MAC address and VLAN number. If the CLI contains an
existing MAC and VLAN, the existing binding entry will be updated with the new parameters; a separate
binding entry will not be created.
Examples This example shows how to configure the static IP source binding:
Switch# config terminal
Switch(config)# ip source binding 11.0.0.1 0000.000A.000B vlan 10 interface
fastethernet6/10
Switch(config)#
Related Commands Command
show ip source binding
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-348
ip source binding ip-address mac-address vlan vlan-id interface interface-name
no ip source binding ip-address mac-address vlan vlan-id interface interface-name
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Binding IP address.
Binding MAC address.
VLAN number.
Binding interface.
Description
Displays IP source bindings that are configured on the
system.
OL-27596 -01