Cisco Catalyst 4500 Series Command Reference Manual page 968

show redundancy
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 14-Jul-04 04:42 by esi
Peer Processor Information :
----------------------------
IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(20)EWA(3
.92), CISCO INTERNAL USE ONLY ENHANCED PRODUCTION VERSION
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 14-Jul-04 0
Switch#
This example shows how to display redundancy facility client information:
Switch# show redundancy clients
clientID = 0
clientID = 30
clientID = 28
clientID = 65000
The output displays the following information:
clientID displays the client's ID number.
•
clientSeq displays the client's notification sequence number.
•
Current redundancy facility state.
•
This example shows how to display the redundancy facility counter information:
Switch# show redundancy counters
Redundancy Facility OMs
rx peer msg routing errors = 0
duplicate client registers = 0
failed to register client = 0
Switch#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-910
BOOT = bootflash:cat4000-i5s-mz.122_20_EWA_392,1
Configuration register = 0x2002
Standby Location = slot 2
Current Software state = STANDBY HOT
Uptime in current state = 2 days, 2 hours, 39 minutes
Image Version = Cisco Internetwork Operating System Software
BOOT = bootflash:cat4000-i5s-mz.122_20_EWA_392,1
Configuration register = 0x2002
clientSeq = 0
clientSeq = 135
clientSeq = 330
clientSeq = 65000
comm link up = 1
comm link down down = 0
invalid client tx = 0
null tx by client = 0
tx failures = 0
tx msg length invalid = 0
client not rxing msgs = 0
null peer msg rx = 0
errored peer msg rx = 0
buffers tx = 1535
tx buffers unavailable = 0
buffers rx = 1530
buffer release errors = 0
Invalid client syncs = 0
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
RF_INTERNAL_MSG
Redundancy Mode RF
GALIOS_CONFIG_SYNC
RF_LAST_CLIENT Switch
OL-27596 -01