Debug Lacp - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

debug lacp

To debug the LACP activity, use the debug lacp command. To disable the debugging output, use the no
form of this command.
Syntax Description
all
event
fsm
misc
packet
Defaults
Debugging of LACP activity is disabled.
Command Modes Privileged EXEC mode
Command History Release
12.1(13)EW
Usage Guidelines
This command is supported only by the supervisor engine and can be entered only from the
Catalyst 4500 series switch console.
Examples This example shows how to enable the LACP miscellaneous debugging:
Switch# debug lacp
Port Aggregation Protocol Miscellaneous debugging is on
Switch#
Related Commands Command
undebug pagp (same as no debug pagp)
OL-27596 -01
debug lacp [all | event | fsm | misc | packet]
no debug lacp
(Optional) Enables all LACP debugging.
(Optional) Enables the debugging of the LACP events.
(Optional) Enables the debugging of the LACP finite state machine.
(Optional) Enables the miscellaneous LACP debugging.
(Optional) Enables the LACP packet debugging.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Disables debugging output.
debug lacp
2-157