Cisco Catalyst 4500 Series Command Reference Manual page 540

monitor session
l3-forward
forward
glean
receive
control-packet
esmp
mtu-exceeded
routed
received
rpf-failure
unknown-port-vlan-mapping
unknown-sa
,
-
both
rx
tx
filter
ip access-group
name
id
vlan vlan_id
packet-type
good
bad
address-type unicast | multicast |
broadcast
Defaults Received and transmitted traffic, as well as all VLANs, packet types, and address types are monitored
on a trunking interface.
Packets are transmitted untagged out the destination port; ingress and learning are disabled.
All packets are permitted and forwarded "as is" on the destination port.
Command Modes Global configuration mode
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-482
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
(Optional) Layer 3 packets.
Specifies special Layer 3 forwards tunnel encapsulation.
Specifies special Layer 3 forwards glean.
Specifies packets addressed to a port.
(Optional) Layer 2 control packets.
(Optional) ESMP packets.
(Optional) Output Layer 3 interface MTU exceeded.
Specifies Layer 3 routed packets.
Specifies packets addressed to a port.
Specifies Multicast RPF failed packets.
(Optional) Packets with missing port-VLAN mapping.
(Optional) Packets with missing source-IP-addresses.
(Optional) Symbol to specify another range of SPAN VLANs;
valid values are from 1 to 4094.
(Optional) Symbol to specify a range of SPAN VLANs.
(Optional) Monitors and filters received and transmitted traffic.
(Optional) Monitors and filters received traffic only.
(Optional) Monitors and filters transmitted traffic only.
Limits SPAN source traffic to specific VLANs.
(Optional) Specifies an IP access group filter, either a name or
a number.
(Optional) Specifies an IP access list name.
(Optional) Specifies an IP access list number. Valid values are 1
to 199 for an IP access list and 1300 to 2699 for an IP expanded
access list.
(Optional) Specifies the VLAN to be filtered. The number is
entered as a single value or a range; valid values are from 1 to
4094.
Limits SPAN source traffic to packets of a specified type.
Specifies a good packet type
Specifies a bad packet type.
Limits SPAN source traffic to packets of a specified address
type. Valid types are unicast, multicast, and broadcast.
OL-27596 -01