Show Mac-Address-Table Address - Cisco Catalyst 4500 Series Command Reference Manual

show mac-address-table address

show mac-address-table address
To display MAC address table information for a specific MAC address, use the
show mac-address-table address command.
Syntax Description mac_addr
interface type slot/port
protocol protocol
vlan vlan_id
Defaults
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
12.2(25)EW
Usage Guidelines For the MAC address table entries that are used by the routed ports, the routed port name is displayed in
the "vlan" column not the internal VLAN number.
The keyword definitions for the protocol variable are as follows:
•
•
•
•
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-822
show mac-address-table address mac_addr [interface type slot/port | protocol protocol | vlan
vlan_id]
48-bit MAC address; the valid format is H.H.H.
(Optional) Displays information for a specific interface; valid values for
type are fastethernet, gigabitethernet, and tengigabitethernet.
(Optional) Specifies a protocol. See the "Usage Guidelines" section for
more information.
(Optional) Displays entries for the specific VLAN only; valid values are
from 1 to 4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Added support for the 10-Gigabit Ethernet interface.
ip specifies the IP protocol.
ipx specifies the IPX protocols.
assigned specifies the assigned protocol entries.
other specifies the other protocol entries.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01