Show Class-Map - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show class-map

To display class map information, use the show class-map command.
Syntax Description
class_name
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.2(25)SG
Examples This example shows how to display class map information for all class maps:
Switch# show class-map
Class Map match-any class-default (id 0)
Match any
Class Map match-any class-simple (id 2)
Match any
Class Map match-all ipp5 (id 1)
Match ip precedence 5
Class Map match-all agg-2 (id 3)
Switch#
This example shows how to display class map information for a specific class map:
Switch# show class-map ipp5
Class Map match-all ipp5 (id 1)
Match ip precedence 5
Switch#
Assume there are two active flows as shown below on Fast Ethernet interface 6/1:
SrcIp
--------------------------------------------------------
192.168.10.10
192.168.10.10
With following configuration, each flow will be policed to a 1000000 bps with an allowed 9000-byte
burst value.
Note If you use the match flow ip source-address|destination-address command, these two flows are
consolidated into one flow and they have the same source and destination address.
OL-27596 -01
show class-map class_name
Name of the class map.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Displays results from the full-flow option.
DstIp
192.168.20.20
192.168.20.20
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
IpProt SrcL4Port DstL4Port
20 6789 81
20 6789 21
show class-map
2-663