Pppoe Intermediate-Agent Format-Type (Interface) - Cisco Catalyst 4500 Series Command Reference Manual

pppoe intermediate-agent format-type (interface)

pppoe intermediate-agent format-type (interface)
This command takes effect only if you enable the pppoe intermediate-agent interface configuration
Note
command.
To set circuit-id or remote-id for an interface, use the pppoe intermediate-agent format-type
command. To unset the parameters, use the no form of this command.
Syntax Description
circuit-id string string
remote-id string string
Defaults No default values for circuit-id and remote-id.
Command Modes Interface configuration mode
Command History Release
12.2(50)SG
Usage Guidelines Use the pppoe intermediate-agent format-type command to set interface-specific circuit-id and
remote-id values. If an interface-specific circuit-id is not set, the system's automatic generated circuit-id
value is used.
Examples This example shows how to set remote-id for an interface:
Switch(config-if)# pppoe intermediate-agent format-type remote-id string user5551983
This example shows how to unset circuit-id for an interface:
Switch(config)# no pppoe intermediate-agent format-type circuit-id
Related Commands Command
pppoe intermediate-agent
(interface)
pppoe intermediate-agent
(interface vlan-range)
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-558
pppoe intermediate-agent format-type {circuit-id | remote-id} string string
no pppoe intermediate-agent format-type {circuit-id | remote-id} string string
ASCII string literal value for circuit-id.
ASCII string literal value for remote-id.
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Enables the PPPoE Intermediate Agent feature on an interface.
Sets the circuit-id or remote-id for an interface vlan-range.
OL-27596 -01