Hw-Module Uplink Select - Cisco Catalyst 4500 Series Command Reference Manual

hw-module uplink select

hw-module uplink select
To select the 10-Gigabit Ethernet, or Gigabit Ethernet uplinks on a Supervisor Engine V-10GE in a
WS-C4510R chassis, or Supervisor 7L-E in a WS-C4507R chassis, use the hw-module uplink select
command.
Supervisor Engine 7L-E is not supported on a ten-slot chassis (WS-C4510R.
Note
Note Option all is not supported on Supervisor Engine 7L-E.
Syntax Description tengigabitethernet
gigabitethernet
all
Defaults tengigabitethernet
Command Modes Global configuration mode
Command History Release
12.2(25)EW
12.2(25)SG
15.0(2)XO
Usage Guidelines On a Supervisor Engine V-10GE (WS-X4516-10GE) in a 10-slot chassis (Catalyst 4510R and 4510R-E),
if a startup configuration with a new uplink mode is copied into flash memory and the system is power
cycled, the system will not come up with the new uplink mode. After copying the startup configuration
with the new uplink mode into flash memory, the uplink mode must be changed to the new uplink mode
through the command interface before the system is power cycled. This ensures that the system comes
up in the new uplink mode.
Supervisor Engine V-10GE and Supervisor Engine II+10GE support 10-Gigabit Ethernet and Gigabit
Ethernet uplink ports. On the Supervisor Engine II+10GE, all uplink ports are always available.
Similarly, when a Supervisor Engine V-10GE is plugged into a W-C4503, W-4506, or W-4507R chassis,
all uplink ports are always available. When a Supervisor Engine V-10GE is plugged into a W-4510R
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-278
hw-module uplink select {tengigabitethernet | gigabitethernet | all}
hw-module uplink select {tengigabitethernet | gigabitethernet} (Sup-7L-E only)
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for the all keyword was added.
The number of uplink ports for Supervisor Engine 7L-E in a WS-C4507R chassis
depends on the supervisor engine mode (single or redundandant) and the uplink
mode configuration (1-Gigabit or 10-Gigabit).
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
(Optional) Specifies the 10-Gigabit Ethernet uplinks.
(Optional) Specifies the Gigabit Ethernet uplinks.
(Optional) Specifies all uplinks (10-Gigabit Ethernet and Gigabit
Ethernet).
OL-27596 -01