Configuring Flex Links And The Mac Address-Table Move Update Feature; Finding Feature Information; Restrictions For Configuring Flex Links And Mac Address-Table Move Update - Cisco Catalyst 2960-XR Configuration Manual

Configuring Flex Links and the MAC
Address-Table Move Update Feature
•
•
•
•
•
•
•
•

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest feature
information and caveats, see the release notes for your platform and software release.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Restrictions for Configuring Flex Links and MAC Address-Table
Move Update
• Flex Links are supported only on Layer 2 ports and port channels.
• You can configure up to 16 backup links.
• You can configure only one Flex Links backup link for any active link, and it must be a different interface
OL-29424-01
Finding Feature Information, page 147
Restrictions for Configuring Flex Links and MAC Address-Table Move Update, page 147
Information About Flex Links and MAC Address-Table Move Update, page 148
How to Configure Flex Links and the MAC Address-Table Move Update Feature, page 154
Monitoring Flex Links and the MAC Address-Table Move Update, page 160
Configuration Examples for Flex Links, page 161
Additional References for Flex Links and MAC Address-Table Move Update, page 165
Feature Information for Flex Links and MAC Address-Table Move Update, page 166
from the active interface.
Catalyst 2960-XR Switch Layer 2 Configuration Guide, Cisco IOS Release 15.0(2)EX1
7
C H A P T E R
147