Debug Nmsp - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

debug nmsp

To the enable debugging of the Network Mobility Services Protocol (NMSP) on the switch, use the
debug nmsp command. This command is available only when your switch is running the cryptographic
(encrypted) software image. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes Privileged EXEC mode
Command History Release
12.2(52)SG
Usage Guidelines
The undebug nmsp command is the same as the no debug nmsp command.
Related Commands Command
show debugging
show nmsp
OL-27596 -01
debug nmsp {all | connection | error | event | packet | rx | tx}
no debug nmsp
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Description
Displays information about the types of debugging that are enabled.
Displays the NMSP information.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
debug nmsp
2-159