Cisco Catalyst 4500 Series Command Reference Manual page 255

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Table 2-2
LLPP TLV Name
Global configuration mode
4-wire-power-management
mac-phy-cfg
management-address
port-description
port-vlan
power-management
system-capabilities
system-description
system-name
Interface configuration mode
inventory-management
location
network-policy
Use the number tlv-name keyword-argument pair to specify the TLV number to be added to the TLV
filter list.
Use the no tlv {name tlv-name | number tlv-number} command to remove individual TLVs from the
TLV filter list.
Use the no device-sensor filter-list lldp list tlv-list-name command to remove the entire TLV list
containing all of the TLVs.
The following example shows how to create an LLDP filter containing a list of TLVs:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor filter-list lldp list lldp-list
Switch(config-sensor-lldplist)# tlv name mac-phy-config
Switch(config-sensor-lldplist)# tlv name system-name
Switch(config-sensor-lldplist)# end
Examples The following example shows how to create an LLDP filter containing a list of TLVs:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor filter-list lldp list lldp-list
Switch(config-sensor-lldplist)# tlv name mac-phy-config
Switch(config-sensor-lldplist)# tlv name system-name
Switch(config-sensor-lldplist)# end
OL-27596 -01
LLDP TLVs
Description
Cisco 4-wire power with MDI TLV
IEEE 802.3 MAC/PHY configuration status TLV
Management address TLV
Port description TLV
Port VLAN ID TLV
IEEE 802.3 DTE power with MDI TLV
System capabilities TLV
System description TLV
System name TLV
LLDP Media Endpoint Devices (MED) inventory management TLV
LLDP MED location TLV
LLDP MED network policy TLV
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
device-sensor filter-list
2-197