Dot1X Critical Eapol - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

dot1x critical eapol

To enable sending EAPOL success packets when a port is critically authorized partway through an EAP
exchange, use the dot1x critical eapol command. To return to the default setting, use the no form of this
command.
Syntax Description
This command has no keywords or variables.
Defaults
The default is to not send EAPOL success packets.
Command Modes Global configuration mode
Command History Release
12.2(31)SG
Examples
This example shows how to enable sending EAPOL success packets:
Switch(config-if)# dot1x critical eapol
Switch(config-if)#
Related Commands Command
dot1x critical
dot1x critical recovery delay
dot1x critical vlan
show dot1x
OL-27596 -01
dot1x critical eapol
no dot1x critical eapol
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Enables the 802.1X critical authentication on a port.
Sets the time interval between port reinitializations.
Assigns a critically authenticated port to a specific VLAN.
Displays dot1x information.
dot1x critical eapol
2-213