Port-Channel Standalone-Disable - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

port-channel standalone-disable

To disable the EtherChannel standalone option in a port channel, use the port-channel
standalone-disable command in interface configuration mode. To enable this option, use the no form
of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
The standalone option is disabled.
Command Modes Interface configuration mode
Command History Release
15.0(2)SG1
Usage Guidelines
This command can only be used when the port channel protocol type is Link Aggregation Control
Protocol (LACP). It allows you to change the current behavior when a physical port cannot bundle with
an LACP EtherChannel.
Examples
The following example shows how to enable the EtherChannel standalone option in a port channel:
Switch(config-if)# no port-channel standalone-disable
Related Commands Command
show etherchannel
OL-27596 -01
port-channel standalone-disable
no port-channel standalone-disable
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Displays EtherChannel information for a channel.
port-channel standalone-disable
2-527