Hw-Module Port-Group - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

hw-module port-group

To select either Gigabit Ethernet or 10-Gigabit Ethernet interfaces on your module, use the hw-module
port-group command.
Syntax Description module
number
port-group number
select
gigabitethernet
tengigabitethernet
Defaults 10 Gigabit.
Command Modes
Global configuration mode
Command History Release
12.2(40)SG
Usage Guidelines Support for this command is available on the Cisco Catalyst 4500 modules that support TwinGig
converter modules, such as the Supervisor Engine 6-E and WS-X4606-10GE-E.
Examples
This example shows how to select Gigabit Ethernet interfaces on a WS-X4606-10GE-E using the
TwinGig Converter:
Switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# hw-module module 1 port-group 1 select gigabitethernet
Switch(config)# exit
Use the show interfaces status command to display your configuration.
Related Commands Command
show hw-module port-group
show interfaces status
OL-27596 -01
hw-module module number port-group number select [gigabitethernet | tengigabitethernet]
Specifies a line module.
Specifies a module which supports TwinGig converter.
Port group number on a switch.
Specifies an interface type; valid values are Gigabit Ethernet and
10-Gigabit Ethernet.
(Optional) Specifies Gigabit Ethernet.
(Optional) Specifies 10-Gigabit Ethernet.
Modification
Support for TwinGig converter module introduced.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Displays how the X2 holes on a module are grouped.
Displays the interface status or a list of interfaces in
error-disabled state.
hw-module port-group
2-273