Show Authentication - Cisco Catalyst 4500 Series Command Reference Manual

show authentication

show authentication
To display the Auth Manager information, use the show authentication command in EXEC or
Privileged EXEC mode.
Syntax Description interface interface
registrations
sessions
session-id session-id (Optional) Specifies an Auth Manager session.
handle handle
mac mac
method method
Command Default
This command has no default settings.
Command Modes
EXEC
Command History Release
12.2(50)SG
Usage Guidelines
Table 2-19
The possible values for the status of sessions are given below. For a session in terminal state, "Authz
Note
Success" or "Authz Failed" are displayed. "No methods" is displayed if no method has provided a result.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-644
show authentication {interface interface | registrations | sessions [session-id session-id] [handle
handle] [interface interface] [mac mac] [method method]
Displays all of the Auth Manager details associated with the specified interface.
Displays details of all methods registered with the Auth Manager.
Displays details of the current Auth Manager sessions (for example, client
devices). If you do not enter any optional specifiers, all current active sessions
are displayed. You can enter the specifiers singly or in combination to display
a specific session (or group of sessions).
(Optional) Specifies the particular handle for which Auth Manager information
is displayed. Range is 1 to 4294967295.
(Optional) Displays Auth Manager session information for a specified MAC
address.
(Optional) Displays all clients authorized by a specified authentication
method. Valid values are as follows:
dot1x
•
mab
•
webauth
•
Modification
This command was introduced.
describes the significant fields shown in the show authentication display.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01