Cisco Catalyst 4500 Series Command Reference Manual page 868

show lacp
This example shows how to display internal information for the interfaces belonging to a specific channel:
Switch# show lacp 1 internal
Flags:
Channel group 1
Port
Fa4/1
Fa4/2
Fa4/3
Fa4/4
Switch#
Table 2-35
Table 2-35
Field
State
LACPDUs Interval
LACP Port Priority
Admin Key
Oper Key
Port Number
Port State
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-810
S - Device sends PDUs at slow rate. F - Device sends PDUs at fast rate.
A - Device is in Active mode.
LACPDUs
Flags State Interval
saC bndl 30s
saC bndl 30s
saC bndl 30s
saC bndl 30s
lists the output field definitions.
show lacp internal Command Output Fields
Description
State of the specific port at the current moment is displayed; allowed
values are as follows:
bndl—Port is attached to an aggregator and bundled with other
•
ports.
susp—Port is in a suspended state; it is not attached to any
•
aggregator.
indep—Port is in an independent state (not bundled but able to
•
switch data traffic. In this case, LACP is not running on the partner
port).
hot-sby—Port is in a hot-standby state.
•
down—Port is down.
•
Interval setting.
Port priority setting.
Administrative key.
Operator key.
Port number.
State variables for the port encoded as individual bits within a single
octet with the following meaning [1]:
bit0: LACP_Activity
•
bit1: LACP_Timeout
•
bit2: Aggregation
•
bit3: Synchronization
•
• bit4: Collecting
• bit5: Distributing
• bit6: Defaulted
bit7: Expired
•
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
P - Device is in Passive mode.
LACP Port Admin Oper
Priority Key Key
32768 100 100
32768 100 100
32768 100 100
32768 100 100
Port Port
Number State
0xc1 0x75
0xc2 0x75
0xc3 0x75
0xc4 0x75
OL-27596 -01