Cisco Catalyst 4500 Series Command Reference Manual page 869

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
This example shows how to display LACP neighbors information for a specific port channel:
Switch# show lacp 1 neighbor
Flags:
Channel group 1 neighbors
Port
Fa4/1
Fa4/2
Fa4/3
Fa4/4
Fa4/1
Fa4/2
Fa4/3
Fa4/4
Switch#
In the case where no PDUs have been received, the default administrative information is displayed in
braces.
This example shows how to display the LACP system identification:
Switch> show lacp sys-id
8000,AC-12-34-56-78-90
Switch>
The system identification is made up of the system priority and the system MAC address. The first two bytes
are the system priority, and the last six bytes are the globally administered individual MAC address associated
to the system.
Related Commands Command
lacp port-priority
lacp system-priority
OL-27596 -01
S - Device sends PDUs at slow rate. F - Device sends PDUs at fast rate.
A - Device is in Active mode.
Partner
System ID
8000,00b0.c23e.d84e
8000,00b0.c23e.d84e
8000,00b0.c23e.d84e
8000,00b0.c23e.d84e
Port Admin
Priority Key
32768 200
32768 200
32768 200
32768 200
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
P - Device is in Passive mode.
Partner
Port Number Age
0x81 29s
0x82 0s
0x83 0s
0x84 0s
Oper Port
Key State
200 0x81
200 0x81
200 0x81
200 0x81
Description
Sets the LACP priority for the physical interfaces.
Sets the priority of the system for LACP.
show lacp
Flags
P
P
P
P
2-811