Match (Class-Map Configuration) - Cisco Catalyst 4500 Series Command Reference Manual

match (class-map configuration)

match (class-map configuration)
To define the match criteria for a class map, use the match class-map configuration command. To
remove the match criteria, use the no form of this command.
Syntax Description access-group
acl-index-or-name
cos cos-list
[lp] dscp dscp-list
[lp] precedence
ip-precedence-list
qos-group value
protocol ip
protocol ipv6
protocol arp
Defaults
No match criteria are defined.
Command Modes
Class-map configuration mode
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-454
match {access-group acl-index-or-name | cos cos-list | [lp] dscp dscp-list | [lp] precedence
ip-precedence-list | qos-group value | protocol [ip | ipv6 | arp]
no match {access-group acl-index-or-name | cos cos-list | [lp] dscp dscp-list | [lp] precedence
ip-precedence-list | qos-group value | protocol [ip | ipv6 | arp]
Number or name of an IP standard or extended access control list (ACL) or
MAC ACL. For an IP standard ACL, the ACL index range is 1 to 99 and 1300
to 1999. For an IP extended ACL, the ACL index range is 100 to 199 and
2000 to 2699.
Lists up to four Layer 2 class of service (CoS) values to match against a
packet. Separate each value with a space. The range is 0 to 7.
(Optional) IP keyword. It specifies that the match is for IPv4 packets only. If
not used, the match is for both IPv4 and IPv6 packets.
Lists up to eight IP Differentiated Services Code Point (DSCP) values to
match against a packet. Separate each value with a space. The range is 0 to
63. You also can enter a mnemonic name for a commonly used value.
(Optional) IP keyword. It specifies that the match is for IPv4 packets only. If
not used, the match is for both IPv4 and IPv6 packets.
Lists up to eight IP-precedence values to match against a packet. Separate
each value with a space. The range is 0 to 7. You also can enter a mnemonic
name for a commonly used value.
Specifies the internally generated qos-group value assigned to a packet on
the input qos classification.
Specifies IP in the Ethernet header. Though visible in the command-line help
strings, the only protocol types supported are IP, IPv6, and ARP.
Specifies IPv6 in the Ethernet header. Though visible in the command-line
help strings the only protocol types supported are IP, IPv6, and ARP.
Specifies ARP in the Ethernet header. Though visible in the command-line
help strings the only protocol types supported are IP, IPv6, and ARP.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01