Duplex - Cisco Catalyst 4500 Series Command Reference Manual

duplex

duplex
To configure the duplex operation on an interface, use the duplex command. To return to the default
setting, use the no form of this command.
Syntax Description
auto
full
half
Defaults Half-duplex operation
Command Modes
Interface configuration mode
Command History Release
12.1(8a)EW
Usage Guidelines Table 2-1
Table 2-1
Interface Type
10/100-Mbps module
100-Mbps fiber
modules
Gigabit Ethernet
Interface
10/100/1000
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-238
duplex {auto | full | half}
no duplex
Specifies the autonegotiation operation.
Specifies the full-duplex operation.
Specifies the half-duplex operation.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
lists the supported command options by interface.
Supported duplex Command Options
Supported
Syntax
duplex [half |
full]
duplex [half |
full]
Not supported.
duplex [half |
full]
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Default Setting Guidelines
half If the speed is set to auto, you will
not be able to set the duplex mode.
If the speed is set to 10 or 100, and
you do not configure the duplex
setting, the duplex mode is set to half
duplex.
half
Not supported. Gigabit Ethernet interfaces are set to
full duplex.
If the speed is set to auto or 1000,
you will not be able to set duplex.
If the speed is set to 10 or 100, and
you do not configure the duplex
setting, the duplex mode is set to half
duplex.
OL-27596 -01