Show Interfaces Counters (Virtual Switch) - Cisco Catalyst 4500 Series Command Reference Manual

show interfaces counters (virtual switch)

show interfaces counters (virtual switch)
To display the traffic that the physical interface sees, use the show interfaces counters command in
EXEC mode.
Syntax Description interface
switch-num
/mod
/port
errors
etherchannel
protocol status
storm-control
Defaults
This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
Cisco IOS XE 3.4.0SG and
15.1(2)SG
Usage Guidelines
The show interfaces counters command displays the number of all of the packets arriving and includes
the number of packets that may be dropped by the interface due to the storm-control settings. To display
the total number of dropped packets, you can enter the show interfaces counters storm-control
command.
The show interfaces counters storm-control command displays the discard count and the level settings
for each mode. The discard count is a total of all three modes.
If you do not enter any keywords, all counters for all modules are displayed.
If you do not specify an interface, the information for all interfaces is displayed.
When you enter the show interfaces interface counters etherchannel command, follow these
guidelines:
•
•
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-714
show interfaces [interface switch-num/mod/port] counters [errors | etherchannel | protocol
status | storm-control]
(Optional) Specifies the interface type.
Specifies the switch number; valid values are 1 and 2.
Specifies the module number.
Specifies the port number.
(Optional) Displays the interface error counters.
(Optional) Displays information about the EtherChannel interface.
(Optional) Displays information about the current status of the enabled
protocols.
(Optional) Displays the discard count and the level settings for each mode.
If interface specifies a physical port, the command displays the message "Etherchannel not enabled
on this interface."
If interface is omitted, the command displays the counters for all port channels (in the system) and
for their associated physical ports.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Modification
Support for this command was introduced on the Catalyst 4500 series
switch.
OL-27596 -01