Cisco Catalyst 4500 Series Command Reference Manual page 670

service-policy (interface configuration)
This example shows how to apply policy map p1 for traffic in VLANs 20 and 400, and policy map p2
for traffic in VLANs 300 through 301:
Switch# configure terminal
Switch(config)# interface gigabitEthernet 6/1
Switch(config-if)# switchport trunk encapsulation dot1q
Switch(config-if)# switchport mode trunk
Switch(config-if)# vlan-range 20,400
Switch(config-if-vlan-range)# service-policy input p1
Switch(config-if-vlan-range)# exit
Switch(config-if)# vlan-range 300-301
Switch(config-if-vlan-range)# service-policy output p2
Switch(config-if-vlan-range)# end
Switch# show policy-map interface gigabitEthernet 6/1 vlan 20
GigabitEthernet6/1 vlan 20
Service-policy input: p1
Class-map: class-default (match-any)
Switch# show policy-map interface gigabitEthernet 6/1
GigabitEthernet6/1 vlan 20
Service-policy input: p1
Class-map: class-default (match-any)
GigabitEthernet6/1 vlan 300
Service-policy output: p2
Class-map: class-default (match-any)
GigabitEthernet6/1 vlan 301
Service-policy output: p2
Class-map: class-default (match-any)
GigabitEthernet6/1 vlan 400
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-612
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
0 packets
Match: any
0 packets
police: Per-interface
Conform: 0 bytes Exceed: 0 bytes
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01