Show Interfaces Link - Cisco Catalyst 4500 Series Command Reference Manual

show interfaces link

show interfaces link
To display how long a cable has been disconnected from an interface, use the show interfaces link
command:
Syntax Description module mod_num
Defaults
This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.2(18)EW
Usage Guidelines
If the interface state is up, the command displays 0:00. If the interface state is down, the time (in hours,
minutes, and seconds) is displayed.
Examples
This example shows how to display active link-level information:
Switch# show interfaces link
Port
Gi1/1
Gi1/2
Gi3/1
Gi3/2
Fa4/1
Fa4/2
Fa4/3
Fa4/4
This example shows how to display inactive link-level information:
Switch# show interfaces link
Port
Gi3/4
Gi3/5
Gi3/6
Gi4/1
In this example, the cable has been disconnected from the port for 1 minute and 28 seconds.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-718
show interfaces link [module mod_num]
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Name
00:00:00
00:00:00
Name
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
(Optional) Limits the display to interfaces on a module.
Down Time
00:00:00
00:00:00
00:00:00
00:00:00
00:00:00
00:00:00
Down Time
1 minute 28 secs
1 minute 28 secs
1 minute 28 secs
1 minute 28 secs
OL-27596 -01