Attach Module - Cisco Catalyst 4500 Series Command Reference Manual

attach module

attach module
To remotely connect to a specific module, use the attach module configuration command.
Syntax Description
mod
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(19)EW
Usage Guidelines This command applies only to the Access Gateway Module on Catalyst 4500 series switches.
The valid values for mod depend on the chassis that are used. For example, if you have a Catalyst 4506
chassis, valid values for the module are from 2 to 6. If you have a 4507R chassis, valid values are from
3 to 7.
When you execute the attach module mod command, the prompt changes to Gateway#.
This command is identical in the resulting action to the session module mod and the remote login
module mod commands.
Examples
This example shows how to remotely log in to an Access Gateway Module:
Switch# attach module 5
Attaching console to module 5
Type 'exit' at the remote prompt to end the session
Gateway>
Related Commands Command
remote login module
session module
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-22
attach module mod
Target module for the command.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Remotely connects to a specific module.
Logs in to the standby supervisor engine using a virtual console.
OL-27596 -01