Configuring Dynamic Mac Address Parameters; Querying Dynamic Addresses - Cisco 200 Series Administration Manual

Managing MAC Address Tables
Dynamic MAC Addresses
STEP 1
STEP 2
STEP 3
STEP 1
STEP 2
Cisco Small Business 200 Series Smart Switch Administration Guide

Configuring Dynamic MAC Address Parameters

Dynamic Addresses Setting Page
The
MAC address table.
To enter the aging interval for dynamic addresses:
Click MAC Address Tables > Dynamic Address Settings. The
Setting Page
opens.
Enter Aging Time. The aging time is a value between the user-configured value
and twice that value minus 1. For example, if you entered 300 seconds, the aging
time is between 300 and 599 seconds.
Click Apply. The Dynamic MAC Address Table is updated.

Querying Dynamic Addresses

Dynamic Addresses Page
The
according to the following criteria:
• Interface type
• MAC addresses
• VLAN
This page displays the dynamically-learned MAC addresses. You can clear the
dynamic addresses from the MAC address table and specify the query criteria to
display a subset of the table, such as the MAC addresses learned on a specific
interface. You can also specify how the query results are sorted. If no filter criteria
are entered, the entire table is displayed.
To perform query dynamic addresses:
Click MAC Address Tables > Dynamic Addresses. The
opens.
Filter
In the block, enter the following query criteria:
• VLAN ID—Enter the VLAN ID for which the table is queried.
• MAC Address—Enter the MAC address for which the table is queried.
enables entering the aging interval for the
enables querying the Dynamic MAC Address table
13
Dynamic Addresses
Dynamic Addresses Page
130