Dot1X Auth-Fail Max-Attempts - Cisco Catalyst 4500 Series Command Reference Manual

dot1x auth-fail max-attempts

dot1x auth-fail max-attempts
To configure the max number of attempts before a port is moved to the auth-fail VLAN, use the
dot1x auth-fail max-attempts command. To return to the default setting, use the no form of this
command.
Syntax Description
max-attempts
Defaults
Default is 3.
Command Modes Interface configuration mode
Command History Release
12.2(25)SG
Examples
This example shows how to configure the maximum number of attempts before the port is moved to the
auth-fail VLAN on Fast Ethernet interface 4/3:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface fastethernet4/3
Switch(config-if)# dot1x auth-fail max-attempts 5
Switch(config-if)# end
Switch#
Related Commands Command
dot1x max-reauth-req
show dot1x
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-208
dot1x auth-fail max-attempts max-attempts
no dot1x auth-fail max-attempts max-attempts
Specifies a maximum number of attempts before a port is moved to the
auth-fail VLAN in the range of 1 to 10.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Sets the maximum number of times that the switch will
retransmit an EAP-Request/Identity frame to the client
before restarting the authentication process.
Displays 802.1x information.
OL-27596 -01