P Wccp Redirect Exclude In - Cisco Catalyst 4500 Series Command Reference Manual

Cisco ios command reference release ios xe 3.4.0sg and ios 15.1(2)sg
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches

p wccp redirect exclude in

To configure an interface to exclude packets received on an interface from being checked for redirection,
use the ip wccp redirect exclude in command in interface configuration mode. To disable the ability of
a router to exclude packets from redirection checks, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Redirection exclusion is disabled.
Command Modes
Interface configuration (config-if)
Command History
Release
12.2(31)SG
IOS XE 3.2(0)SG
(15.0(2)SG)
IOS XE 3.3.0 SG
(15.1(1)SG)
Usage Guidelines
This configuration command instructs the interface to exclude inbound packets from any redirection
check. Note that the command is global to all the services and should be applied to any inbound interface
that will be excluded from redirection.
This command is intended to be used to accelerate the flow of packets from a cache engine to the Internet
as well as allow for the use of the Web Cache Communication Protocol (WCCP) v2 packet return feature.
Examples
In the following example, packets arriving on GigabitEthernet interface 3/1 are excluded from WCCP
output redirection checks:
Router (config)# interface gigabitethernet 3/1
Router (config-if)# ip wccp redirect exclude in
Related Commands
Command
ip wccp
ip wccp redirect
ip wccp redirect out
OL-27596 -01
ip wccp redirect exclude in
no ip wccp redirect exclude in
Description
Enables support of the WCCP service for participation in a service group.
Enable packet redirection on an inbound or outbound interface using Web
Cache Communication Protocol (WCCP).
Configures redirection on an interface in the outgoing direction.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Modification
Support introduced on the Catalyst 4500 series switch.
Support extended to Supervisor Engine 6-E, Supervisor Engine
6L-E, Catalyst 4900M, and Catalyst 4948E.
Supported extended to Supervisor Engine 7-E and Supervisor
Engine 7L-E.
p wccp redirect exclude in
2-365

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents