Cisco Catalyst 4500 Series Command Reference Manual page 195

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Current configuration : 63 bytes
!
interface Vlan1
ip address 10.0.0.1 255.0.0.0
counter ipv4
end
To remove the counter assignment, use the no counter command.
Note
If you have already assigned the maximum number of counters, the counter command fails, displaying
the following error message:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# interface fa3/2
Switch(config-if)# no switchport
Switch(config-if)# counter ipv6
Counter resource exhausted for interface fa3/2
Switch(config-if)# end
Switch#
00:24:18: %SYS-5-CONFIG_I: Configured from console by console
In this situation, you must release a counter from another interface so the new interface can use it.
OL-27596 -01
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
End with CNTL/Z.
counter
2-137