Nmsp Attachment Suppress - Cisco Catalyst 4500 Series Command Reference Manual

nmsp attachment suppress

nmsp attachment suppress
To suppress reporting attachment information from a specified interface, use the nmsp attachment
suppress interface command. This command is available only when your switch is running the
cryptographic (encrypted) software image. Use the no form of this command to report attachment
information.
Syntax Description This command has no arguments or keywords.
Defaults
Attachment information is reported.
Command Modes
Interface configuration mode
Command History Release
12.2(52)SG
Usage Guidelines
Use the nmsp attachment suppress interface configuration command to configure an interface to not
send attachment notifications to a Cisco Mobility Services Engine (MSE).
Examples
This example shows how to configure an interface to not send attachment information to the MSE:
Switch(config)# switch interface gigabitethernet1/2
Switch(config-if)# nmsp attachment suppress
Switch(config-if)#
Related Commands Command
nmsp
show nmsp
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-494
nmsp attachment suppress
no nmsp attachment suppress
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
Description
Configures Network Mobility Services Protocol (NMSP) on the
switch.
Displays the NMSP information.
OL-27596 -01