Show Qos Aggregate Policer - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show qos aggregate policer

To display QoS aggregate policer information, use the show qos aggregate policer command.
Syntax Description
aggregate_name
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
Usage Guidelines This command is not supported on the Supervisor Engine 6-E and Catalyst 4900M chassis.
The aggregate policer name is case sensitive.
Examples This example shows the output if you do not enter any keywords:
Switch# show qos aggregate policer
Policer aggr-1
Rate(bps):10000000 Normal-Burst(bytes):1000000
conform-action:transmit exceed-action:policed-dscp-transmit
Policymaps using this policer:
Switch#
Related Commands Command
qos trust
OL-27596 -01
show qos aggregate policer [aggregate_name]
(Optional) Named aggregate policer.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
ipp5-policy
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Description
Defines a named aggregate policer.
show qos aggregate policer
2-903