Debug Condition Vlan - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

debug condition vlan

To limit the VLAN debugging output for a specific VLAN, use the debug condition vlan command. To
disable the debugging output, use the no form of this command.
Syntax Description
vlan_id
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
Usage Guidelines If you attempt to remove the only VLAN condition set, you will be prompted with a message asking if
you want to abort the removal operation. You can enter n to abort the removal or y to proceed with the
removal. If you remove the only condition set, it could result in the display of an excessive number of
messages.
Examples This example shows how to limit the debugging output to VLAN 1:
Switch# debug condition vlan 1
Condition 4 set
Switch#
This example shows the message that is displayed when you attempt to disable the last VLAN debug
condition:
Switch# no debug condition vlan 1
This condition is the last vlan condition set.
Removing all conditions may cause a flood of debugging
messages to result, unless specific debugging flags
are first removed.
Proceed with removal? [yes/no]: n
% Operation aborted
Switch#
OL-27596 -01
debug condition vlan {vlan_id}
no debug condition vlan {vlan_id}
Number of the VLAN; valid values are from 1 to 4096.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Support for extended VLAN addresses added.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
debug condition vlan
2-145