Cisco Catalyst 4500 Series Command Reference Manual page 192

cos (netflow-lite exporter submode)
cos (netflow-lite exporter submode)
NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To specify a CoS value for the NetFlow-lite collector, use the cos command. To delete the value, use the
no form of this command.
Syntax Description
cos-value
Defaults 0
Command Modes netflow-lite exporter submode
Command History Release
15.0(2)SG
Usage Guidelines This option allows you to set the CoS value of VLAN tags for packet samples exported by the fpga alone.
Examples This example shows how to specify a CoS value for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-134
cos cos-value
no cos cos-value
Specifies a CoS value for the NetFlow-lite collector. Valid values from 0 to 7.
Modification
Support for this command was introduced on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01