Config Syslog Host - Extreme Networks EAS 200-24p Switch CLI Manual

config syslog host

Description
The config syslog command configures the syslog host configurations. The user can choose and report a
specific level of messages to a specific host. When the user chooses a specific level for a specific host,
messages which are at that severity level or higher will be reported to the specified host.
Format
config syslog host [<index> | all] {severity [emergency | alert | critical |
error | warning | notice | informational | debug | <level 0-7>] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] | state [enable
| disable]}
Parameters
host - The host index or all hosts.
●
<index> - Enter the host index value here.
●
all - Specifies that all the host indexes will be used.
●
severity - (Optional) Specifies the severity level.
●
emergency - Severity level 0
●
alert - Severity level 1
●
critical - Severity level 2
●
error - Severity level 3
●
warning - Severity level 4
●
notice - Severity level 5
●
informational - Severity level 6
●
debug - Severity level 7
●
- <level 0-7> - Enter the severity level value here. This value must be between 0 and 7.
facility - (Optional) Some of the operating system daemons and processes have been assigned
●
Facility values. Processes and daemons that have not been explicitly assigned a Facility may use any
of the "local use" facilities or they may use the "user-level" Facility. Those Facilities that have been
designated are shown below. This facility setting will be put in the syslog packet when it is sent to a
specific syslog server.
local0 - Specifies that the user-defined facility will be set to local 0.
●
local1 - Specifies that the user-defined facility will be set to local 1.
●
local2 - Specifies that the user-defined facility will be set to local 2.
●
local3 - Specifies that the user-defined facility will be set to local 3.
●
local4 - Specifies that the user-defined facility will be set to local 4.
●
local5 - Specifies that the user-defined facility will be set to local 5.
●
local6 - Specifies that the user-defined facility will be set to local 6.
●
local7 - Specifies that the user-defined facility will be set to local 7.
●
Extreme Networks EAS 200-24p Switch CLI Manual
config syslog host
791