Config Stp Ports - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 37: Multiple Spanning Tree Protocol (MSTP) Command List

config stp ports

Description
This command can configure all the parameters of ports, except for Internal Path Cost and Port Priority.
Format
config stp ports <portlist> {externalCost [auto | <value 1-200000000>] |
hellotime <value 1-2> | migrate [yes | no] | edge [true | false | auto] | p2p
[true | false | auto] | state [enable | disable]| restricted_role [true |
false] | restricted_tcn [true | false] | fbpdu [enable | disable]}
Parameters
<portlist> - Enter a list of ports used for the configuration here.
●
external_cost - (Optional) The path cost between MST regions from the transmitting Bridge to the
●
CIST Root Bridge. It is only used at CIST level.
auto - Specifies that the external cost value will be set to automatic.
●
<value 1-200000000> - Enter the external cost value here. This value must be between 1 and
●
200000000.
hellotime - (Optional) The default value is 2 . This parameter is for MSTP version. For STP and
●
RSTP version, uses the per system hellotime parameter.
<value 1-2> - Enter the hello time value here. This value must be between 1 and 2.
●
migrate - (Optional) Operation of management in order to specify the port to send MSTP BPDU for
●
a delay time.
yes - Specifies that the MSTP BPDU for a delay time will be sent.
●
no - Specifies that the MSTP BPDU for a delay time will not be sent.
●
edge - (Optional) To decide if this port is connected to a LAN or a Bridged LAN.
●
true - Specifies that the specified port(s) is edge.
●
false - Specifies that the specified port(s) is not edge.
●
auto - In auto mode, the bridge will delay for a period to become edge port if no bridge BPUD is
●
received. The default is auto mode.
p2p - (Optional) To decide if this port is in Full-Duplex or Half-Duplex mode.
●
true - Specifies that the port(s) is in Full-Duplex mode.
●
false - Specifies that the port(s) is in Half-Duplex mode.
●
auto - Specifies that the port(s) is in Full-Duplex and Half-Duplex mode.
●
state - (Optional) To decide if this port supports the STP functionality.
●
enable - Specifies that STP functionality on the port(s) is enabled.
●
disable - Specifies that STP functionality on the port(s) is disabled.
●
restricted_role - (Optional) To decide if this port not to be selected as Root Port. The default value is
●
false.
true - Specifies that the port can be specified as the root port.
●
false - Specifies that the port can not be specified as the root port.
●
572
Extreme Networks EAS 200-24p Switch CLI Manual