Extreme Networks EAS 200-24p Switch CLI Manual page 155

<value 0-255> - Enter the protocol ID used here.
●
user_define - (Optional) Specifies that the rule will apply to the IP protocol ID and that the mask
●
options behind the IP header, which has a length of 20 bytes.
<hex 0x0-0xffffffff> - Enter the user-defined mask value here.
●
mask - Specifies an additional mask parameter that can be configured.
●
<hex 0x0-0xffffffff> - Enter the mask value here.
●
packet_content - A maximum of 11 offsets can be specified. Each offset defines 2 bytes of data which
●
is identified as a single UDF field. The offset reference is also configurable. It can be defined to start
at the end of the tag, the end of the ether type or the end of the IP header. To qualify the fields
before the end of the tag, the destination address, source address, and the VLAN tags are also
included
offset_chunk_1 – (Optional) Specifies the value of the packet bytes to be matched. Offset chunk 1
●
will be used.
- <hex 0x0-0xffffffff> - Enter the offset chunk 1 mask here.
offset_chunk_2 - (Optional) Specifies the value of the packet bytes to be matched. Offset chunk 2
●
will be used.
- <hex 0x0-0xffffffff> - Enter the offset chunk 2 mask here.
offset_chunk_3 - (Optional) Specifies the value of the packet bytes to be matched. Offset chunk 3
●
will be used.
- <hex 0x0-0xffffffff> - Enter the offset chunk 3 mask here.
offset_chunk_4 - (Optional) Specifies the value of the packet bytes to be matched. Offset chunk 4
●
will be used.
- <hex 0x0-0xffffffff> - Enter the offset chunk 4 mask here.
ipv6 - Specifies that the rule applies to IPv6 fields.
●
class - (Optional) Specifies the value of the IPv6 class.
●
<value 0-255> - Enter the IPv6 class value here. This value must be between 0 and 255.
●
flowlabel - (Optional) Specifies the value of the IPv6 flow label.
●
<hex 0x0-0xffff> - Enter the IPv6 flow label mask used here.
●
source_ipv6 - (Optional) Specifies the value of the IPv6 source address.
●
<ipv6addr> - Enter the source IPv6 address used for this configuration here.
●
mask - (Optional) Specifies an additional mask parameter that can be configured.
●
<ipv6mask> - Enter the source IPv6 mask here.
●
destination_ipv6 - (Optional) Specifies the value of the IPv6 destination address.
●
<ipv6addr> - Enter the destination IPv6 address used for this configuration here.
●
mask - (Optional) Specifies an additional mask parameter that can be configured.
●
<ipv6mask> - Enter the destination IPv6 mask here.
●
tcp - (Optional) Specifies to configure the TCP parameters.
●
src_port - Specifies the value of the IPv6 Layer 4 TCP source port.
●
- <value 0-65535> - Enter the TCP source port value here. This value must be between 0 and
65535.
mask - Specifies an additional mask parameter that can be configured.
●
- <hex 0x0-0xffff> - Enter the TCP source port mask value here.
dst_port - (Optional) Specifies the value of the IPv6 Layer 4 TCP destination port.
●
Extreme Networks EAS 200-24p Switch CLI Manual
config access_profile
155