Debug Show Status - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 19: Debug Software Command List

debug show status

Description
This command is used to display the debug handler state and the specified module's debug status. If
the input module list is empty, the states of all registered modules which support debug module will be
shown.
Format
debug show status {module <module_list>}
Parameters
module – (Optional) Specifies the module list.
●
<module_list> - Enter the module list here.
●
Restrictions
Only Administrator-level users can issue this command.
Example
To display the specified module's debug state:
EAS 200-24p:admin#debug show status module MSTP
Command: debug show status module MSTP
Debug Global State
MSTP
EAS 200-24p:admin#
To display the debug state:
EAS 200-24p:admin#debug show status
Command: debug show status
Debug Global State
MSTP
IMPB
ERPS
EAS 200-24p:admin#
328
: Enabled
: Disabled
: Enabled
: Disabled
: Disabled
: Disabled
Extreme Networks EAS 200-24p Switch CLI Manual