Config Terminal Width - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 2: Basic Command List

config terminal width

Description
The command is used to set current terminal width.
The usage is described as below:
1 Users login and configure the terminal width to 120, this configuration take effect on this login
section. If users implement "save" command, the configuration is saved. After users log out and log
in again, the terminal width is 120.
2 If user did not save the configuration, another user login, the terminal width is default value.
3 If at the same time, two CLI sessions are running, once section configure to 120 width and save it,
the other section will not be effected, unless it log out and then log in.
Format
config terminal width [default | <value 80-200>]
Parameters
default - The default setting of terminal width. The default value is 80.
●
<value 80-200> - The terminal width which will be configured. The width is between 80 and 200
●
characters.
Restrictions
None.
Example
To configure the current terminal width:
EAS 200-24p:admin# config terminal width 120
Command: config terminal width 120
Success.
EAS 200-24p:admin#
42
Extreme Networks EAS 200-24p Switch CLI Manual