state - Specifies that the IPv4 interface state will be set to enabled or disabled.
●
enable - Specifies that the IPv4 interface sate will be enabled.
●
disable - Specifies that the IPv4 interface sate will be disabled.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an interface's IPv4 network address:
EAS 200-24p:admin#config ipif System ipaddress 192.168.69.123/24 vlan default
Command: config ipif System ipaddress 192.168.69.123/24 vlan default
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
config ipif
231