Debug Buffer - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 19: Debug Software Command List

debug buffer

Description
Use this command to show the debug buffer's state, or dump, clear, or upload the debug buffer to a
TFTP server.
Format
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr>
<path_filename 64>]
Parameters
utilization - Display the debug buffer's state.
●
dump - Display the debug message in the debug buffer.
●
clear - Clear the debug buffer.
●
upload_toTFTP - Upload the debug buffer to a TFTP server specified by IP address.
●
<ipaddr> - Specifies the IPv4 address of the TFTP server.
●
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can be a
●
relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrator users can issue this command.
Example
To show the debug buffer's state:
EAS 200-24p:admin# debug buffer utilization
Command: debug buffer utilization
Allocate from:System memory pool
Total size:2 MB
Utilization rate:30%
EAS 200-24p:admin#
To clear the debug buffer:
EAS 200-24p:admin# debug buffer clear
Command: debug buffer clear
Success.
EAS 200-24p:admin#
322
Extreme Networks EAS 200-24p Switch CLI Manual