Extreme Networks EAS 200-24p Switch CLI Manual page 148

Chapter 6: Access Control List (ACL) Command List
802.1p - (Optional) Specifies the 802.1p priority tag mask.
●
ethernet_type - (Optional) Specifies the Ethernet type mask.
●
ip - Specifies this is a IPv4 mask.
●
vlan - (Optional) Specifies a VLAN mask. Only the last 12 bits of the mask will be considered.
●
<hex 0x0-0x0fff> -Enter the VLAN mask value here.
●
source_ip_mask - (Optional) Specifies a source IP address mask.
●
<netmask> - Enter the source IP address mask here.
●
destination_ip_mask - (Optional) Specifies a destination IP address mask.
●
<netmask> - Enter the destination IP address mask here.
●
dscp - (Optional) Specifies the DSCP mask.
●
icmp - (Optional) Specifies that the rule applies to ICMP traffic.
●
type - Specifies the type of ICMP traffic.
●
code - Specifies the code of ICMP traffic
●
igmp - (Optional) Specifies that the rule applies to IGMP traffic.
●
type - Specifies the type of IGMP traffic.
●
tcp - (Optional) Specifies that the rule applies to TCP traffic.
●
src_port_mask - Specifies the TCP source port mask.
●
- <hex 0x0-0xffff> - Enter the TCP source port mask here.
dst_port_mask - Specifies the TCP destination port mask.
●
- <hex 0x0-0xffff> - Enter the TCP destination port mask here.
flag_mask - (Optional) Specifies the TCP flag field mask.
●
all – Specifies that all the flags will be used for the TCP mask.
●
urg – Specifies that the TCP flag field will be set to 'urg'.
●
ack - Specifies that the TCP flag field will be set to 'ack'.
●
psh - Specifies that the TCP flag field will be set to 'psh'.
●
rst - Specifies that the TCP flag field will be set to 'rst'.
●
syn - Specifies that the TCP flag field will be set to 'syn'.
●
fin - Specifies that the TCP flag field will be set to 'fin'.
●
udp - (Optional) Specifies that the rule applies to UDP traffic.
●
src_port_mask - Specifies the UDP source port mask.
●
- <hex 0x0-0xffff> - Enter the UDP source port mask here.
dst_port_mask - Specifies the UDP destination port mask.
●
- <hex 0x0-0xffff> - Enter the UDP destination port mask here.
protocol_id_mask - (Optional) Specifies that the rule applies to IP protocol ID traffic.
●
<0x0-0xff> - Enter the protocol ID mask here.
●
user_define_mask - (Optional) Specifies that the rule applies to the IP protocol ID, and that the
●
mask option behind the IP header length is 20 bytes.
<hex 0x0-0xffffffff> - Enter a user-defined mask value here.
●
packet_content_mask - Specifies the packet content mask. Only one packet_content_mask profile can
●
be created.
offset_chunk_1 - (Optional) Specifies that the offset chunk 1 will be used.
●
148
Extreme Networks EAS 200-24p Switch CLI Manual