Config Dhcp_Relay Add Vlanid - Extreme Networks EAS 200-24p Switch CLI Manual

config dhcp_relay add vlanid

Description
This command adds an IP address as a destination to forward (relay) DHCP/BOOTP packets. If there is
an IP interface in the VLAN and it has configured a DHCP server at the interface level, then the
configuration at the interface level has higher priority. In this case, the DHCP server configured on the
VLAN will not be used to forward the DHCP packets.
Format
config dhcp_relay add vlanid <vlan_id_list> <ipaddr>
Parameters
vlanid - Specifies the VLAN ID list used for this configuration.
●
<vlan_id_list> - Enter the VLAN ID list used for this configuration here.
●
<ipaddr> - Enter the DHCP/BOOTP server IP address used here.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a DHCP/BOOTP server 10.43.21.12 to VLAN 1 to 10:
EAS 200-24p:admin# config dhcp_relay add vlanid 1-10 10.43.21.12
Command: config dhcp_relay add vlanid 1-10 10.43.21.12
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
config dhcp_relay add vlanid
339