Create Igmp_Snooping Static_Group - Extreme Networks EAS 200-24p Switch CLI Manual

create igmp_snooping static_group

Description
This command allows you to create an IGMP snooping static group. Member ports can be added to the
static group. The static member and the dynamic member port form the member ports of a group.
The static group will only take effect when IGMP snooping is enabled on the VLAN. For those static
member ports, the device needs to emulate the IGMP protocol operation to the querier, and forward the
traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packet destined for this specific group to
static member ports.
The static member port will only affect V2 IGMP operation.
The Reserved IP multicast address 224.0.0.X must be excluded from the configured group.
The VLAN must be created first before a static group can be created.
Format
create igmp_snooping static_group [vlan<vlan_name 32> | vlanid <vlanid_list>]
<ipaddr>
Parameters
vlan - Specify the name of the VLAN on which the router port resides.
●
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters long.
●
vlanid - Specify the ID of the VLAN on which the router port resides.
●
<vlanid_list> - Enter the VLAN ID here.
●
<ipaddr> - Specify the multicast group IP address.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IGMP snooping static group for VLAN 1, group 239.1.1.1:
EAS 200-24p:admin# create igmp_snooping default 239.1.1.1
Command: create igmp_snooping default 239.1.1.1
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
create igmp_snooping static_group
393