Config Per_Queue Bandwidth_Control - Extreme Networks EAS 200-24p Switch CLI Manual

config per_queue bandwidth_control

Description
Used to configure per port CoS bandwidth control.
Format
config per_queue bandwidth_control {ports [<portlist> | all]} <cos_id_list 0-
7> {{min_rate [no_limit | <value 64-1024000>]} max_rate [no_limit | <value 64-
1024000>]}
Parameters
ports - (Optional) Specifies a range of ports to be configured.
●
<portlist> - Enter the list of port used for this configuration here.
●
all - For set all ports in the system, you may use "all" parameter. If no parameter is specified,
●
system will set all ports.
<cos_id_list 0-7> - Specifies a list of priority queues. The priority queue number is ranged from 0 to
●
7.
min_rate - (Optional) Specifies that one of the parameters below (no_limit or <value m-n) will be
●
applied to the mini-rate at which the above specified class will be allowed to receive packets.
no_limit - Specifies that there will be no limit on the rate of packets received by the above
●
specified class.
<value 64-1024000> - Specifies the packet limit, in Kbps, that the above ports will be allowed to
●
receive. If the specified rate is not multiple of minimum granularity, the rate will be adjusted.
max_rate - (Optional) Specifies that one of the parameters below (no_limit or <value m-n >) will be
●
applied to the maximum rate at which the above specified class will be allowed to transmit packets.
no_limit - Specifies that there will be no limit on the rate of packets received by the above
●
specified class.
<value 64-1024000> - Specifies the packet limit, in Kbps, that the above ports will be allowed to
●
receive. If the specified rate is not multiple of minimum granularity, the rate will be adjusted.
Restrictions
Only Administrator level can issue this command.
Extreme Networks EAS 200-24p Switch CLI Manual
config per_queue bandwidth_control
659