Config Bpdu_Protection Recovery_Interval - Extreme Networks EAS 200-24p Switch CLI Manual

config bpdu_protection recovery_interval

Description
When a port enters the 'under attack' state, it can be disabled or blocked based on the configuration.
The state can be recovered manually or by the auto recovery mechanism. This command is used to
configure the auto-recovery timer. To manually recover the port, the user needs to disable and re-enable
the port.
Format
config bpdu_protection recovery_timer [<sec 60-1000000> | infinite]
Parameters
recovery_timer - Specified the bpdu_protection Auto-Recovery recovery_timer. The default value of
●
recovery_timer is 60.
<sec 60 –1000000> - The timer (in seconds) used by the Auto-Recovery mechanism to recover the
●
port. The valid range is 60 to 1000000.
infinite - The port will not be auto recovered.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the bpdu_protection recovery_timer to 120 seconds for the entire switch:
EAS 200-24p:admin# config bpdu_protection recovery_timer 120
Commands: config bpdu_protection recovery_timer 120
Success.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
config bpdu_protection recovery_interval
241