Traceroute6 - Extreme Networks EAS 200-24p Switch CLI Manual

traceroute6

Description
Used to trace the IPv6 routed path between the switch and a destination end station.
Format
traceroute6 <ipv6addr> {ttl <value 1-60> | port <value 30000-64900> | timeout
<sec 1-65535> | probe <value 1-9>}
Parameters
<ipv6addr> - Specifies the IPv6 address of the destination end station.
●
ttl - (Optional) The time to live value of the trace route request. This is the maximum number of
●
routers that a trace route packet can pass. The traceroute command will cross while seeking the
network path between two devices. The range for the TTL is 1 to 60 hops.
<value 1-60> - Enter the time to live value here. This value must be between 1 and 60.
●
port - (Optional) The port number. The value range is from 30000 to 64900.
●
<value 30000-64900> - Enter the port number here. This value must be between 30000 and 64900.
●
timeout - (Optional) Defines the timeout period while waiting for a response from the remote device.
●
A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
<sec 1-65535> - Enter the timeout period value here. This value must be between 1 and 65535
●
seconds.
probe - (Optional) The number of probing. The range is from 1 to 9. If unspecified, the default value
●
is 1.
<value 1-9> - Enter the probing number value here. This value must be between 1 and 9.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
Trace the IPv6 routed path between the switch and 3000::1:
EAS 200-24p:admin# traceroute6 3000::1 probe 3
Command: traceroute6 3000::1 probe 3
1 <10 ms. 1345:142::11
2 <10 ms. 2011:14::100
3 <10 ms. 3000::1
Trace complete.
EAS 200-24p:admin#
Extreme Networks EAS 200-24p Switch CLI Manual
traceroute6
827