Table of Contents
Advertisement
Customizing the chassis and host names
Perform the following steps to establish an Ethernet connection to the device.
1.
Remove the shipping plug from the Ethernet port on the active management module.
The active management module has the LED labeled ACTIVE on the front panel illuminated in blue.
2.
Insert one end of an Ethernet cable into the Management Ethernet port.
FIGURE 29 Port-side view of the SLX 9030/9030-T Switch
1.
Console/management port
2.
USB port
3.
1Gb/10Gb SFP+ ports (SLX 9030) or 1GB/10GBASE-T
ports (SLX 9030-T)
3.
Connect the other end to 1G, 100 MbE, or 10 MbE Ethernet LAN.
4.
Complete any additional device configuration procedures for the device using one of the following steps:
•
Log in to the device using a serial console connection and admin login.
•
Log in to the device through a Telnet or SSH session using the chassis management IP address and admin login.
Customizing the chassis and host names
To configure a chassis and host name, complete the following task.
The chassis and host names can be up to 30 characters long; can include letters, numbers, hyphens, and underscore characters; and
must begin with a letter.
Extreme recommends that you customize the chassis name for each platform because some of the system logs refer to the platform by
its chassis name.
1.
Log in to the device using one of the following methods:
•
A serial console connection to the active management module. The active management module has the LED labeled
ACTIVE on the front panel illuminated in blue.
•
A Telnet session using the chassis management IP address.
2.
Log in to the device using admin as your login name. If you have not changed the default password, use password.
60
4.
10Gb/40Gb QSFP+ port
5.
10Gb/25Gb/40Gb/100Gb capable QSFP28 ports
ExtremeSwitching SLX 9030 Hardware Installation Guide
9035691-02 Rev AD
Advertisement
Table of Contents
