Config Gvrp - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 3: 802.1Q VLAN Command List

config gvrp

Description
The config gvrp timer command set the GVRP timer's value. The default value for Join time is 200
milliseconds; for Leave time is 600 milliseconds; for LeaveAll time is 10000 milliseconds.
Format
config gvrp [timer {join <value 100-100000> | leave <value 100-100000> |
leaveall <value 100-100000> } | nni_bpdu_addr [dot1d | dot1ad]]
Parameters
timer - Specifies that the GVRP timer parameter will be configured.
●
join - (Optional) Specifies the Join time will be set.
●
<value 100-100000> - Enter the join time used here. This value must be between 100 and 100000.
●
leave - (Optional) Specifies the Leave time will be set.
●
<value 100-100000> - Enter the leave time used here. This value must be between 100 and 100000.
●
leaveall - (Optional) Specifies the LeaveAll time will be set.
●
<value 100-100000> - Enter the leave all time used here. This value must be between 100 and
●
100000.
nni_bpdu_addr - Used to determine the BPDU protocol address for GVRP in service provide site. It
●
can use 802.1d GVRP address, 802.1ad service provider GVRP address or a user defined multicast
address. The range of the user defined address is 0180C2000000 - 0180C2FFFFFF.
dot1d - Specifies that the NNI BPDU protocol address value will be set to Dot1d.
●
dot1ad - Specifies that the NNI BPDU protocol address value will be set to Dot1ad.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the Join time to 200 milliseconds:
EAS 200-24p:admin# config gvrp timer join 200
Command: config gvrp timer join 200
Success.
EAS 200-24p:admin#
66
Extreme Networks EAS 200-24p Switch CLI Manual