Create Ipif - Extreme Networks EAS 200-24p Switch CLI Manual

Chapter 11: Basic Commands Command List

create ipif

Description
This command is used to create an IP interface.
Format
create ipif <ipif_name 12> {<network_address>} <vlan_name 32> {secondary |
state [enable | disable] | proxy_arp [enable | disable] {local [enable |
disable]}}
Parameters
ipif - Specifies the name of the IP interface.
●
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters long.
●
<network_address> - (Optional) Specifies the IPv4 networkaddress (xxx.xxx.xxx/xx). It specifies a
●
host address and length of network mask.
<vlan_name 32> - Enter the VLAN name used here. This name can be up to 32 characters long.
●
secondary - (Optional) Specifies the IPv4 secondary interface to be created.
●
state - (Optional) Specifies the state of the IP interface.
●
enable - Specifies that the IP interface state will be enabled.
●
disable - Specifies that the IP interface state will be disabled.
●
proxy_arp - (Optional) Enable or disable of proxy ARP function. It is for IPv4 function. Default:
●
Disabled.
enable - Specifies that the proxy ARP option will be enabled.
●
disable - Specifies that the proxy ARP option will be disabled.
●
local - (Optional) This setting controls whether the system provides the proxy reply for the ARP
●
packets destined for IP address located in the same interface as the received interface. When proxy
ARP is enabled for an interface, the system will do the proxy reply for the ARP packets destined for
IP address located in a different interface. For ARP packets destined for IP address located in the
same interface, the system will check this setting to determine whether to reply.
enable - Specifies that the local option will be enabled.
●
disable - Specifies that the local option will be disabled.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
228
Extreme Networks EAS 200-24p Switch CLI Manual