Extreme Networks EAS 200-24p Switch CLI Manual page 149

- <value 0-31> - Enter the offset chunk 1 value here. This value must be between 0 and 31.
- <hex 0x0-0xffffffff> - Enter the offset chunk 1 mask here.
offset_chunk_2 - (Optional) Specifies that the offset chunk 2 will be used.
●
- <value 0-31> - Enter the offset chunk 2 value here. This value must be between 0 and 31.
- <hex 0x0-0xffffffff> - Enter the offset chunk 2 mask here.
offset_chunk_3 - (Optional) Specifies that the offset chunk 3 will be used.
●
- <value 0-31> - Enter the offset chunk 3 value here. This value must be between 0 and 31.
- <hex 0x0-0xffffffff> - Enter the offset chunk 3 mask here.
offset_chunk_4 - (Optional) Specifies that the offset chunk 4 will be used.
●
- <value 0-31> - Enter the offset chunk 4 value here. This value must be between 0 and 31.
- <hex 0x0-0xffffffff> - Enter the offset chunk 4 mask here.
ipv6 - (Optional) Specifies this is the IPv6 mask.
●
class - (Optional) Specifies the IPv6 class.
●
flowlabel - (Optional) Specifies the IPv6 flow label.
●
source_ipv6_mask - (Optional) Specifies an IPv6 source sub-mask.
●
<ipv6mask> - Enter the source IPv6 mask value here.
●
destination_ipv6_mask - (Optional) Specifies an IPv6 destination sub-mask.
●
<ipv6mask> -Enter the destination IPv6 mask value here.
●
tcp - (Optional) Specifies that the rule applies to TCP traffic.
●
src_port_mask - Specifies an IPv6 Layer 4 TCP source port mask.
●
<hex 0x0-0xffff> - Enter the TCP source port mask value here.
●
des_port_mask - Specifies an IPv6 Layer 4 TCP destination port mask.
●
<hex 0x0-0xffff> - Enter the TCP destination port mask value here.
●
udp - (Optional) Specifies that the rule applies to UDP traffic.
●
src_port_mask - Specifies the UDP source port mask.
●
<hex 0x0-0xffff> - Enter the UDP source port mask value here.
●
dst_port_mask - Specifies the UDP destination port mask.
●
<hex 0x0-0xffff> - Enter the UDP destination port mask value here.
●
icmp - (Optional) Specifies a mask for ICMP filtering.
●
type - Specifies the inclusion of the ICMP type field in the mask.
●
code - Specifies the inclusion of the ICMP code field in the mask.
●
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Extreme Networks EAS 200-24p Switch CLI Manual
create access_profile
149