Extreme Networks EAS 200-24p Switch CLI Manual page 180

Chapter 7: Access Control List (ACL) Egress Command List
<ipv6addr> - Enter the source IPv6 source address here.
●
mask - Specifies the IPv6 source address mask here.
●
- <ipv6mask> - Enter the IPv6 source address mask value here.
destination_ipv6 - (Optional) Specifies the value of IPv6 destination address.
●
<ipv6addr> - Enter the source IPv6 destination address here.
●
mask - Specifies the IPv6 destination address mask here.
●
- <ipv6mask> - Enter the IPv6 destination address mask value here.
tcp - (Optional) Specifies the TCP protocol
●
src_port - Specifies the value of the IPv6 layer 4 TCP source port.
●
- <value 0-65535> - Enter the IPv6 TCP source port value here. This value must be between 0
and 65535.
mask - Specifies the IPv6 TCP source port mask here.
●
- <hex 0x0-0xffff> - Enter the IPv6 TCP source port mask value here.
dst_port - Specifies the value of the IPv6 layer 4 TCP destination port.
●
- <value 0-65535> - Enter the IPv6 TCP destination port value here. This value must be between
0 and 65535.
mask - Specifies the IPv6 TCP destination port mask here.
●
- <hex 0x0-0xffff> - Enter the IPv6 TCP destination port mask value here.
udp - (Optional) Specifies the UDP protocol.
●
src_port - Specifies the value of the IPv6 layer 4 UDP source port.
●
- <value 0-65535> - Enter the IPv6 UDP source port value here. This value must be between 0
and 65535.
mask - Specifies the IPv6 UDP source port mask here.
●
- <hex 0x0-0xffff> - Enter the IPv6 UDP source port mask value here.
dst_port - Specifies the value of the IPv6 layer 4 UDP destination port.
●
- <value 0-65535> - Enter the IPv6 UDP destination port value here. This value must be
between 0 and 65535.
mask - Specifies the IPv6 UDP destination port mask here.
●
- <hex 0x0-0xffff> - Enter the IPv6 UDP destination port mask value here.
icmp - (Optional) Specifies that the following parameters configured will apply to the ICMP
●
configuration.
type - Specifies that the rule will apply to the ICMP type traffic value.
●
- <value 0-255> - Enter the ICMP traffic type value here. This value must be between 0 and 255.
code - Specifies that the rule will apply to the ICMP code traffic value.
●
- <value 0-255> - Enter the ICMP code traffic value here. This value must be between 0 and 255.
vlan_based - The rule applies on the specified VLAN.
●
vlan - Specifies the VLAN name.
●
- <vlan_name 32> - Enter the VLAN name used for this configuration here. This name can be
up to 32 characters long.
vlanid - Specifies a VLAN ID.
●
- <vlanid 1-4094> - Enter the VLAN ID used for this configuration here. This value must be
between 1 and 4094.
180
Extreme Networks EAS 200-24p Switch CLI Manual